DSDSC-200 Sample Questions & Answers

Refer to the exhibit.
The user expires Replay 2.
Which page(s) are deleted?

When replacing a defective SC4020 controller with a new controller, the engineer notices that the new controller does NOT fully initialize. The system runs SOOS version 6.5.30.
Which three actions should the engineer take? (Choose three.)

Which characteristic of OLTP workloads needs to be considered when optimizing OLTP workloads on the SC array?

During failover testing, an engineer finds that the iSCSI connection failed over properly when a physical link was disconnected. The FC connection did NOT failover when a physical link was disconnected.
Which configuration is causing this issue?

An engineer needs to install an SC8000 with four FC ports in each controller and two FC switches set up in a dual fabric. Each controller also has two 10 Gb iSCSI ports. All iSCSI ports are connected to an ethernet switch. The system uses virtual ports.
How many fault domains are required?

An engineer needs to configure a server HBA port to connect to the storage array via FC. The storage is configured in legacy port mode.
The engineer needs to provide full connectivity from the storage array to the server HBA port.
Which two zone configurations on the FC switch should the engineer use to meet the requirement? (Choose two.)