HPE6-A41 sample questions

Question 1

Refer to the figure.

A network administrator executes this command on an ArubaOS switch, Switch-2:

Switch-2(config)#ip route 10.1.100.0/24 10.1.1.1

The administrator successfully pings Device 1 at 10.1.100.42 from Switch-2. However, Device 2 cannot ping Device 1.

The administrator confirms that Device 1 is correctly set up.

What should the administrator check on Switch-2 to resolve this issue?

Accepted Answer

that IP routing is enabled

Answer

that ARP proxy is enabled

Answer

that spanning tree is disabled

Answer

that ICMP is enabled

Question 2

Refer to the figure. What should the network administrator do to permit Switch-1 to route traffic from a client in 10.1.11.0/24 to a client in 10.1.12.0/24?

Accepted Answer

Enable IP routing.

Answer

Enable proxy ARP.

Answer

Configure a static route to 10.1.11.0/24 and a static route to 10.1.12.0/24.

Answer

Enable OSPF routing on VLAN 11 and on VLAN 12 in the same area.

Question 3

How many operating system image files can a network administrator load on an ArubaOS switch?

Accepted Answer

two

Answer

three

Answer

four

Answer

unlimited

Question 4

Refer to the figure. Originally, all four switches had the same region configuration. VLAN 14 was added to Switch_D and then mapped to instance 2. How does this affect the MSTP topology?

Accepted Answer

Load sharing is lost, one of the uplinks is blocked for all traffic on Switch_D

Answer

Load sharing is lost, one of the uplinks is blocked for all traffic on Switch_C and Switch_D.

Answer

All connectivity is lost, both uplinks are blocked on Switch_D.

Answer

A Layer 2 loop exists and will cause sporadic connectivity issues.

Question 5

Refer to the figure. The network administrator wants to place contractor clients and employee clients in different broadcast domains. How should the administrator achieve this goal?

Accepted Answer

Assign the switch ports connected to contractor clients to one VLAN and ports connected to employee clients to another VLAN. Extend the VLANs between the switches.

Answer

Add a router in between Switch 1 and Switch 2. Configure a different subnet on each router interface.

Answer

Create two MSTP instances on each switch. Assign ports connected to contractor clients to one instance and ports connected to employee clients to the other instance.

Answer

Create two device profiles. Apply one profile to ports connected to contractor clients, and apply the other profile to ports connected to employee clients.

Question 6

Refer to the figure. All of the switches shown in the figure are ArubaOS switches. Where should the network administrator configure an IP helper address of 10.1.1.10?